No hot water is one of the few plumbing problems the whole house notices within minutes. Some causes are a two-minute fix. Some mean the system is finished. Here is how to tell the difference, and what we check when we come out. Repairs are part of our hot water service across Richmond and the inner east.
VBA licensed -124643
5.0 from 27 Google reviews
Free quotes
$60 call out on service work
Based in Richmond
Check the power or the gas supply first, because a tripped circuit or an interrupted gas supply looks exactly like a broken system.
If you smell gas at any point, stop and follow what to do if you smell gas before anything else.
Most faults are in the parts that do the heating or the parts that control safety, and most of those parts can be replaced on their own.
| System | Common faults |
|---|---|
| Electric storage | Failed element, failed thermostat |
| Gas storage | Pilot that will not stay lit, faulty thermocouple or gas control |
| Continuous flow | Ignition faults, error codes, low gas supply to the unit |
| Any storage tank | Relief valve dripping or stuck, worn tempering valve |
A tempering valve fault looks different from a heating fault: the water is hot in one room and lukewarm in another. The common questions below explain that one.
When the tank itself is leaking. A leak from the cylinder, as opposed to a valve or fitting, cannot be repaired, and the system needs replacing.
A repair is also hard to justify when the same fault keeps coming back, or when the parts and labour come close to the price of a new unit. In that case we will say so and talk you through options for a new system.
Turn off the cold water isolation valve on the pipe going into the system, then switch off the power or gas to the unit. That stops more water going in and stops the heating while it waits for us.
Move anything valuable away from the water and put down towels. If the leak is inside, near power points or wiring, turn that circuit off at the switchboard.
Based in Richmond and servicing the surrounding suburbs, including: Abbotsford, Collingwood, Fitzroy, Carlton, Cremorne, South Yarra, Hawthorn, Kew, Camberwell, Balwyn, Malvern, Armadale, Brunswick, St Kilda and Middle Park.











That pipe is usually the relief valve drain. A small release while the tank heats can be normal. A steady stream, or a valve that never stops, usually means the valve or the water pressure needs attention.
Usually. A pilot that will not stay lit often points to the thermocouple or the gas control, and both are replaceable parts. If a draught or a flue problem is blowing it out, that gets fixed too.
That pattern usually points to the tempering valve, which lowers the temperature to the bathroom but not the kitchen (Victorian Building Authority). Tempering valves wear over time and can be serviced or replaced on their own.
Free quotes. $60 call out on service work. VBA licence 124643 (the VBA now trades as the Building and Plumbing Commission).